The Arduino IDE/Cloud Editor checks your sketch’s storage space and dynamic memory usage and prints a message after compilation. Learn what these messages mean and how they relate to potential errors.

In this article:

• When the message is printed
• If the sketch size is within board limits
• If the sketch exceeds available space

When the message is printed

Whenever you click the Verify or Upload button, the IDE/Cloud Editor will compile your sketch. At the end of the compilation process, it will check that the compiled sketch doesn’t exceed the storage limits of the board.

The output will look something like this:

The message is normal and expected output any time you Verify or Upload a sketch.

If the sketch size is within board limits

If both program storage space and dynamic memory usage are less than 100%, the compilation process has been completed successfully:

• In Arduino IDE, a “Done compiling” notification will appear briefly in the bottom-right corner.
• If you clicked the Verify button, nothing more will happen.
• If you clicked the Upload button, the IDE/Cloud Editor will now try to upload the sketch to your board.

Console output during sketch upload

The process of uploading a sketch to the board is a separate step from the compilation process. When the sketch is being uploaded, additional lines may be printed depending on your board and editor settings. In some cases, warnings or other messages from the underlying upload tools may appear. In other cases, nothing else is printed during the upload process. Errors that occur during upload are unrelated to the sketch size and memory usage message.

Some upload tools and protocols may not print any message in the console to indicate a successful upload. Instead, look for the following:

• In Arduino IDE, a “Done uploading” notification appears in the bottom-right corner.
• In the Cloud Editor, the console border turns green with a “Success” message.
• The upload tool may print warnings or other information, sometimes highlighted in red, but the output does not end with a Failed uploading message.

Unless the console output ends with a Failed upload error message, the upload process was probably successful. If you’re unsure, try using the board in your project and see if it works as expected, or upload a simple example like Blink (File > Examples > 01.Basics > Blink).

If a Failed uploading error did occur, it’s important to note that it’s not related to sketch size and memory usage. Instead, see Errors when uploading a sketch for help with troubleshooting uploads.

If the sketch exceeds available space

If either program storage space or dynamic memory usage is more than 100%, you will get a compilation error:

• The compilation error message will be one of the following:
  • data section exceeds available space in board – occurs if program storage space is more than 100%.
  • text section exceeds available space in board – occurs if dynamic memory is more than 100%.
• See Reduce the size and memory usage of your sketch.

Further reading

• For other compilation errors, see If your sketch doesn’t compile.